] [Thread] [Date] [Author]

["oswaldo aiffil" <oswaldo.aiffil(--nospam--at)jantesa.com.ve>]

Good afternoon Bill:
A193 Gr B7 characteristics are the followings:

ASTM SPEC			Fy, ksi (MPa)		Fut, ksi (MPa)		Diameter range inches(mm)

A193 Gr B7			105 (720)			125 (860)			to 2-1/2 (64).
				95 (660)			115 (790)			over 2-1/2 (64) to
												4 (102).
				75 (515)			125 (860)			over 4 (102) to
												7 (180).
There is a note which reads: "NG, galvanizing is not an option in the ASTM
specification".
The source of this information is "Design of Anchor Bolts in Petrochemical
Facilities" prepared by the ASCE Petrochemical Energy Committee, ASCE Task
Committee on Anchor Bolt Design.
I hope it helps!
Best Regards,
Oswaldo Aiffil
Structural Engineer
Caracas, Venezuela

-----Mensaje original-----
De: Bill Polhemus [mailto:bpolhem(--nospam--at)swbell.net]
Enviado el: Monday, October 23, 2000 4:11 PM
Para: seaint(--nospam--at)seaint.org
Asunto: A 193-B7


I need the scoop on this Anchor Bolt material. Need the Fy and Fu values.

Thanks.